| # Modifying the interpreter settings is tricky because they don't take effect |
| # until we create a new command interpreter, which should be merely an |
| # implementation detail. This leads to confusing and unexpected scenarios. |
| # |
| # Below are a few scenarios that we should fix. |
| |
| # CONTINUE: 123456789 |
| # STOP-NOT: 111111111 |
| # STOP-NOT: 123456789 |
| |
| # FIXME: Should stop |
| # RUN: %lldb -b -o 'settings set interpreter.stop-command-source-on-error false' -s %S/Inputs/StopCommandSource.in | FileCheck %s --check-prefix CONTINUE |
| |
| # FIXME: Should continue |
| # RUN: not %lldb -b -s %S/Inputs/DontStopCommandSource.in -o 'bogus' -o 'print 111100000 + 11111' | FileCheck %s --check-prefix STOP |
| |
| # FIXME: Should continue |
| # RUN: not %lldb -b -o 'settings set interpreter.stop-command-source-on-error false' -o 'bogus' -o 'print 123400000 + 56789' | FileCheck %s --check-prefix STOP |
| |
| # FIXME: Should continue |
| # RUN: not %lldb -b -s %S/Inputs/DontStopCommandSource.in | FileCheck %s --check-prefix STOP |
| |
| # FIXME: Should continue |
| # RUN: not %lldb -b -o 'settings set interpreter.stop-command-source-on-error true' -s %S/Inputs/DontStopCommandSource.in | FileCheck %s --check-prefix STOP |